27520 Medicaid reimbursement rate by state (2026)

• Order. States are listed from the highest published rate to the lowest. No single unit is shared by 8 or more states for 27520, so the order is by published amount and is not a like-for-like rank.
• Medicaid rate. The most the state's fee-for-service program pays for one unit, as published. 40 of the 49 states list more than one rate for 27520, by modifier, provider type or setting; the table shows the one that matches the provider level and setting used across states, without add-ons.
• Unit. Of the 49 states, 2 publish 27520 per unit and 1 per base unit, and 46 schedules print no unit at all (a flat amount per service).
• Per hour. 27520 is not billed in time units in these states, so no hourly figure is shown.
• Managed-care plans. The rule the state sets for its plans on this rate. What each rule means is explained below.
• % of Medicare. Medicare amounts exist for 27520, but no state's Medicaid unit matches Medicare's billing unit closely enough to compute a percentage.
• Source and date. Each Source link opens the state's own document; “since” is the date the rate took effect.

Published rates for 27520 run from $9.30 in New Jersey to $593.67 in Alaska. The two publish it in different units (no unit printed versus base unit), so part of that gap is the unit rather than the price. Half the states pay more than the median of $266.46 and half pay less. The usual reasons for a spread like this in physician & professional rates:

• Modifiers such as professional or technical component, bilateral, multiple procedure and assistant at surgery change the amount paid, and states apply them with their own percentages.
• Some states pay physician services as a percentage of the Medicare fee schedule; others keep a schedule of their own that may not have been rebased for years.
• Primary-care and pediatric add-ons, enhanced rates for certain specialties and targeted increases for access problems change individual codes without moving the rest of the schedule.

Timing matters too. 30 states set the current rate for 27520 in 2026 or later, while 8 states still pay a rate that took effect in 2022 or earlier. A state that has not updated its rate in years will drift down the ranking as others raise theirs.

What a plan pays for 27520 is negotiated privately, but the state decides how much room there is to negotiate. Here is how the rules break down across the 49 states.

In 11 states, the published rate binds plans: a floor, a pass-through or a state-set rate. In 23 states, plans negotiate and the published rate is a benchmark or out-of-network default. The rule for the remaining 15 states is not classified yet.

• Plans negotiate; the published rate applies out of network (23 states). In-network rates can be above or below the published rate. The published rate is the benchmark both sides know, and the fallback if no contract is signed.
• Plans must pay at least the published rate (11 states). The published rate is your floor. Negotiate up from it, and if a plan pays less, the contract provision is the basis for a payment dispute.

Plan-negotiated rates are never estimated here. To see the rule and its citation for a particular state, open that state's managed-care page, for example Alaska managed care.

27520 is a CPT surgery code in the physician & professional line, billed mostly by physicians, nurse practitioners, physician assistants and other licensed practitioners. Surgical codes are paid once per procedure. The fee can include a global period of related care before and after the procedure, and modifiers for multiple, bilateral or assistant procedures raise or reduce what is actually paid.

Physician-fee-schedule codes are billed per service: one unit is one occurrence unless the code itself is defined by time or quantity. Where a state publishes separate facility and non-facility amounts, the non-facility (office) amount is usually higher because the practice carries the overhead.

Medicare's 2026 physician fee schedule pays $324.54–$481.89 for 27520 (non-facility), depending on the Medicare locality. That is a useful reference point, but Medicare and Medicaid can define the unit differently, so compare only where the units match.

Before billing, confirm the rate, unit and any modifier with the state's current schedule or the plan: the amounts here are as published, not a guarantee of payment.